Configuring Snmp Trap Managers And Traps - Paradyne FrameSaver 9783 Installation Instructions Manual

Configuring SNMP Trap Managers and Traps

Once the FrameSaver unit is connected to the network, SNMP trap managers and
SNMP traps can be configured.
"
Procedure
To enter SNMP managers and configure traps:
1. Select SNMP Traps.
Main Menu → Configuration → Management and Communication → SNMP Traps
2. Configure the following:
– Enable SNMP Traps.
– Identify the total Number of Trap Managers.
– Specify the IP address of the NMS(s) to which traps will be sent.
– Specify the Initial Route Destination for the Trap Manager(s).
– Select desired trap categories.
3. Save the configuration.
Verifying End-to-End Management Path
"
Procedure
After installation of a remote unit, run an ATM Ping test from the Hotwirer GranDSLAM.
1. From the Hotwire ATM Line Card's Main Menu, select the ATM Ping test.
Diagnostics → ATM Ping (D-C)
2. Enter a VPI of 0 and a VCI of 35. Select a Direction of Endpoint. Select Start.
3. If the test is successful, select a Direction of Network. Select Start.
If both tests are successful, the VC has been tested from end to end.
17