Advertisement
Is tracking set correctly?
* There is no problem if the two blades overlap and are flush with each other.
* If both blades are visible, carry out adjustment in accordance with page 20 of the Users Manual.
Needs
adjustment
OK
Rudder sub trim
Aileron sub trim
Elevator sub trim
Adjust the rudder sub trim so as to turn off the rudder LED of
the fuselage.
* Place the fuselage on a level table, etc., and turn on the controller switch.
* Warm up the motor by slowly rotating for a while.
* Adjust the controller rudder sub trim so as to turn off the following LED.
* Turn the rudder sub trim right when lit green, and left when lit red.
Rudder LED
(Right side face: the lower hole of two)
Adjust the upper rotor head in accordance with page 17 of
the Users Manual.
Confirm pirouette and adjust the upper rotor head.
* Perform pirouette in the left and right direction.
* Adjust the upper rotor head so as to turn left and right at the same rate as the lower rotor head.
Front
Right
Left
3.
When lit red
Flight
adjustment
Tracking and rudder
When lit green
Advertisement
