Subscribe to Our Youtube Channel
Related Manuals for ACME LED-275 D
Summary of Contents for ACME LED-275 D
-
Page 1: User Manual
LED-275 D User Manual Please read the instructions carefully before use Innovation, Quality, Performance... - Page 2 EC - Declaration of Conformity We declare that our products (lighting equipments) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 89/336/EEC. EN 55103-1:1996, EN 55103-2:1996, EN 61000-3-2:2006, EN 61000-3-3:1995+A1:2001+A2:2005 &...
- Page 3 9. Fixture Cleaning The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the fixture’s optics. TABLE OF CONTENTS Clean with soft cloth using normal glass cleaning fluid.
- Page 4 1. Safety Introductions 8. Troubleshooting Following are a few common problems that may occur during operation. Here are some suggestions for easy troubleshooting: Please read the instructions carefully which includes important information about the installation, operation and maintenance. WARNING A. The fixture does not work, no light Please keep this User Manual for future consultation.
- Page 5 7. DMX512 Connections Direct sunlight can cause heat to build up inside of the unit, which will seriously damage The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. unit. For power supply, do not connect in series much more than 37 units, use another mains supply for next 37 units.
- Page 6 4. How To Set The Fixture 5.3 DMX Controller 4.1 Control Panel Use universal DMX controller to control the units, you have to set DMX address from 1 to 512 channel so that the units can receive DMX signal. Press the MENU button up to when the is showing on the display.
- Page 7 2. By easy controller 4.2 Main Function 3. By DMX controller To select any functions, press MENU button until the required one is shown on the display. No need to turn the unit off when you change the DMX address, as new DMX address Select the function by ENTER button and the display will blink.
- Page 8 MENU button again. Slave Mode Display Inverse Press the MENU button up to when the is shown on the display. Pressing ENTER Press MENU button until is blinking on the display. Use DOWN and UP button to button, Use DOWN and UP button to select the (master) or (slave 1) or select...
Need help?
Do you have a question about the LED-275 D and is the answer not in the manual?
Questions and answers