Connecting Relay Modules - ADEMCO VISTA-20PS Series Installation And Setup Manual

Connecting Relay Modules

1. Mount either remotely or in the control panel.
2. Connect to control's keypad terminals using the
connector harness supplied with the module. Use
standard 4-conductor twisted cable for long wiring
runs.
3. Set each module's device address according to the
table at right.
4. Connect the desired field wiring to the unit's relay
contact terminals.
U L
For UL installation requirements, refer to the
Installation Instructions for the 4204.
(4229 Module is shown in the 4219/4229 Expansion Zones paragraph on page 2-7)
4204
4204
DIP SWITCH
FOR SETTING DEVICE ADDRESS
AND ENABLING/DISABLING TAMPER
COVER TAMPER (REED) SWITCH
4-PIN CONSOLE PLUG
EITHER OR BOTH
CAN BE USED
TB1
13 14 15 16
Figure 11. 4204 Connections to Control
Mounting and Wiring the Control
Notes
• Use 4204 or 4229 modules.
• Supervision: 4204 and 4229 modules are
supervised against removal. The module's device
address is displayed as follows if a module is
disconnected from the control's terminals, or if
the module cover is removed and the tamper
jumper is installed:
Alpha: CHECK xx Wire Expansion
FAULT xx Wire Expansion
ALARM xx Wire Expansion
Fixed-Glass: lxx (or 91 if field *199 set for 2-digit
display)
where "xx is the module's address.
• If communication/tamper failure occurs on a
device with zones wired to it, all zones on the
device will be displayed in their respective
partitions.
Relay Module Addresses
4204 Address
no. 1 12
no. 2 13
no. 3 †
14
no. 4 †
15
† Applies to VISTA-20P.
†† Not available if zone doubling used
RELAY 4
TYPICAL
(SHOWN "OFF")
RELAY
3
RELAY
2
RELAY
1
YEL
DATA IN
FROM CONTROL
BLK
(–) GROUND
GRN DATA OUT
TO CONTROL
RED
(+) 12V
4229 Address
no. 1 (zn 09-16) †† 07
no. 2 (zn 17-24) 08
no. 3 † (zn 25-32)
09
no. 4 † (zn 33-40)
10
no. 5 † (zn 41-48)
11
C
NC
NO
C
NC
NO
C
NC
NO
C
NC
NO
TB2
2-11