Powerline Carrier Devices - ADEMCO VISTA-20PS Series Installation And Setup Manual

Installation and Setup Guide

Powerline Carrier Devices

1. Install the powerline carrier devices according to the
instructions included with each.
VISTA-20P: Up to 16 devices (if no relays are used)
VISTA-15P: Up to 8 devices (if no relays are used)
2. Use Programming Mode to enter the device house ID
in data field*27, and enter the unit code using *79
Output Device menu Mode.
3. See connections diagram in the AC Wiring paragraph
for connecting the 4300/1321X10 transformer to the
triggers.
Canada: Use the PSC04 Powerline Interface as
shown below.
2-12
8-PIN TRIGGER CONNECTOR
1 3 4 5 6 7 8
SA4120XM-1 CABLE
SYNC
COM
DATA
PSC04 Powerline Interface Connections
Notes
• When using Powerline Carrier devices, you must
use a 4300 or 1321X10 Transformer instead of
the 1321 Transformer.
• The 4300/1321X10 Transformer provides AC
power to the control panel, and also supplies
signals from the control panel through the
premises AC wiring to the Powerline Carrier
devices (which are plugged into AC outlets). You
can then make devices that are plugged into
Powerline Carrier devices perform various
functions in response to commands you enter at
the security system keypads.
U L
Powerline Carrier devices and the 4300
Transformer are not UL Listed for fire or burglary
functions and are intended for home automation.
X-10 PSC04
POWERLINE INTERFACE
1 2 3 4
BLK
MODULAR PHONE CORD (not supplied)
1 - BLACK
GRN
2 - RED
3 - GREEN
4 - YELLOW
RED
YEL