Table of Contents
Advertisement
ELECTRICAL SAFETY
When using the far infrared foam bed, basic precautions should always be followed, including the
following:
Read all instructions before using this unit.
DANGER - To reduce the risk of electric shock:
WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:
1.
The far infrared foam bed should never be left unattended when plugged in. Unplug from outlet
when not in use and before cleaning.
2.
Excessive heating may occur and cause fire, electric shock, or injury to persons.
3.
Close supervision is necessary when this unit is used by, on, or near children, invalids or
disabled persons.
4.
Use this unit only for its intended use as described in this manual. Do not use for other purpose
that is not recommended by the manufacturer.
5.
STOP using this unit IMMEDIATELY if it has a damaged cord or plug. If it is not working
properly, been dropped, damaged, or dropped into water.
6.
Keep the cord away from any heated surface.
7.
Do not use it outdoors.
8.
Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
9.
To disconnect, turn the remote control or controller to the "OFF" position, then remove plug from
outlet.
10. Do not use on an infant or on a sleeping person.
CABLE STORAGE:
11.
Velcro strap as illustrated. Do not lay it on the ground to avoid cable damage.
THE DIMENSION OF HEATING PAD:
There is a heating pad inside the foam bed. The heating pad is 27.55" (length) x 11.81" ( width) , or
700mm (length) x 300mm (width) in dimension. The heating area is illustrated as below:
When not in use, wrap the cable around the frame with the enclosed
Heating Pad
6
Advertisement
Table of Contents
