kozy heat Lakefield 56150 Installation Manual page 26

INSTALLATION OF THIS FAN SHOULD BE DONE ONLY BY A QUALIFIED INSTALLER
This optional #LKF-028 fan kit includes: - Right & left fan assemblies - mounted
MAKE SURE HOUSEHOLD BREAKER IS SHUT OFF PRIOR TO WORKING ON ANY ELECTRICAL LINES.
WARNING
This appliance is equipped with a three-prong (grounding) plug for protection against shock hazard and should be plugged into
a properly grounded three-prong receptacle. Do not cut or remove grounding prong from plug.
This appliance must be electrically grounded and connected in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 Current Edition, or the Canadian electrical Code CSA C22.1.
NOTE
This fan will not operate unless speed control has been turned ON and sufficient heat has been applied to temperature control switch. The fan will
turn ON and OFF automatically as fireplace heats and cools. Adjust fan to desired speed while it is running.
We recommend that an electrical outlet be installed near fireplace.
1. Locate (4) mounting studs underneath rear of fireplace.
2. Slide fan underneath fireplace, lift up, aligning (4) mount holes / slots in fan bracket to
mounting studs under firebox. Secure with (4) nuts (included).
3. Attach fan cover to back of fireplace by aligning holes in cover to holes at back of
fireplace. Secure with remaining (2) screws.
4. Mount speed control box onto left side of gas valve bracket by aligning slots in box to
holes in bracket. Secure with (2) black phillips head screws, included.
5. Place temperature control switch (magnet attached) onto bottom of firebox as close to
center as possible.
6. Plug fan cord into receptacle on speed control box.
7. Plug speed control box cord into a properly grounded three-prong receptacle.
8. Turn speed control counter-clockwise until it clicks. This is the OFF position.
9. Turn speed control ON by turning knob clockwise past click - this is the highest setting.
TEMPERATURE CONTROL SWITCH POSITION
Before adjusting temperature control switch, unplug 3-prong plug on fan cord from receptacle.
Adjust position of temperature control switch to a warmer location under firebox to turn fan ON
sooner or move it to a cooler location under firebox to turn fan ON later. The fan will turn on when
sensor in temperature control switch reaches 110° F and will turn OFF when sensor reaches 90° F.
After adjustment, plug 3-prong plug on fan cord into receptacle.
Temperature Control Switch
Figure 4b
OPTIONAL FAN KIT
- Temperature control switch with magnet attached
- Speed Control Box with 8ft. cord
Ground
4
- Fan cover plate
- (4) Flange nuts
- (4) Phillips head screws (black)
Figure 4a