Set Reader Mode - IBC DCX Series User Manual

Set Reader Mode

| x
x 1
online mode (use this also for Hybrid Mode in combination with the X108 command, page 42)
2
prox dump mode
5
collection mode
Sets the mode of the reader.
Mode 5 is the standard data collection mode.
Mode 1 is an online mode. Data from scanned cards is immediately transmitted out serially and is not stored,
unless Hybrid Mode is also turned on.
Mode 2 is a special mode for dumping the bit pattern of proximity cards, including prox, iclass, piv, and mifare.
The prox bits (1's and 0's) are transmitted through the serial interface when the card is presented.
This mode is useful when attempting to identify the format of the prox card.
Get Reader Parameters
?
rr m 1 2 3 id
returns:
rr
data record length, not including date/time, id, or description
m
current reader mode, 1, 2, or 5
1
0=date/time not being recorded, 1=date/time included
2
0=reader id not included, 1=reader id included
3
0=reader description not included, 1=reader description included
i
5 character reader id
d
10 character reader description
Returns the parameters set in the reader.
DCX Series User's Guide
Version 2.11 Rev. 0 13 August 2013
8