Table of Contents
Advertisement
Magstripe Masking
X061 ll p1 ll1 p2 ll2
X062 p3 ll3 p4 ll4 p5 ll5
X063 ll p1 ll1 p2 ll2
X064 p3 ll3 p4 ll4 p5 ll5
X065 ll p1 ll1 p2 ll2
X066 p3 ll3 p4 ll4 p5 ll5
X067 ll p1 ll1 p2 ll2
X068 p3 ll3 p4 ll4 p5 ll5
X069 ll p1 ll1 p2 ll2
X070 p3 ll3 p4 ll4 p5 ll5
X071 ll p1 ll1 p2 ll2
X072 p3 ll3 p4 ll4 p5 ll5
ll
Lenth of the barcode. If any barcode matches this length, the barcode data is masked.
p1
1st position
ll1
data for 1st position
p2
2nd position
ll2
data for 2nd position
p3
3rd position
ll3
data for 3rd position
p4
4th position
ll4
data for 4th position
p5
5th position
ll5
data for 5th position
NOTES
•
Magstripe masking allows you to select specific portions of the magstripe to include in the saved data. By using the
masking, you can effectively "mask out" any unwanted portion of the magstripe data. You can also insert characters into the
data using this command.
•
There are 2 masks for each of the 3 magnetic stripe tracks. Each mask specifies a specific length magstripe. If the mag-
stripe which is read matches the length for the mask (on that particular track), then the mask is applied. If a magstripe does
not match either of the mask lengths, then it is not masked. Use a length value of 00 to turn off the mask (ll=00).
•
To select a specific part of the magstripe to include in the saved data, set the p(x) parameter to the starting position in the
magstripe, and set the ll(x) parameter to the length to select. You can also set the length to 000 which selects all of the data
starting at the position p(x).
DCX Series User's Guide
Version 2.11 Rev. 0
(track 1, mask 1, part 1)
(track 1, mask 1, part 2)
(track 1, mask 2, part 1)
(track 1, mask 2, part 2)
(track 2, mask 1, part 1)
(track 2, mask 1, part 2)
(track 2, mask 2, part 1)
(track 2, mask 2, part 2)
(track 3, mask 1, part 1)
(track 3, mask 1, part 2)
(track 3, mask 2, part 1)
(track 3, mask 2, part 2)
13 August 2013
35
Advertisement
Table of Contents
