Programming Commands - IBC DCX Series User Manual

DCX Series User's Guide
Version 2.11 Rev. 0 13 August 2013

PROGRAMMING COMMANDS

You program the DCX reader by sending serial commands. Each command must be followed by a carriage return (hex 0D).
The reader will respond with OK if the command is accepted, or NOK if the command is not accepted.
If your reader also supports reading barcodes, you can also embed commands within a barcode. To make a barcode containing
a command, the barcode must be in code39, and start with a %U.
Note that any spaces shown in the commands are not part of the command. They are used solely for readability.
To program any TCP/IP related parameters, refer to the IBC TCP/IP Programmers Guide.
5