Table of Contents
Advertisement
Proximity General Input Settings
X073 m k b p s
m
1 = accept wiegand data only; 2 = accept only aba data; 3 = accept wiegand and aba
k
1 = masking on; 2=masking off
b
1=beep on good read; 0= no beep
p
1= parity check for 26 and 28 bit cards; 0 = no parity check
s
1=passthru mode on; 0=passthru mode off
NOTES
•
Set the m parameter to 1 to read wiegand formatted cards only. Set to 2 for aba cards and 3 to read both.
•
Set the k parameter to 1 to turn on masking for prox input data
•
Set the b parameter to a 1 to turn on the good read beep
•
If p is set to 1, then the reader will validate the parity for 26 bit and 28 bit cards. If the parity is incorrect, the reader will
ignore the card.
•
Set s to 1 to pass thru the wiegand data undisturbed (1's and 0's) out the serial connection when in mode 1.
DCX Series User's Guide
Version 2.11 Rev. 0
13 August 2013
37
Advertisement
Table of Contents
