Assembly Instructions; Operating Instructions - Kärcher HD 3000 Operator's Manual

HD3000 Manual 9/20/02 5:28 PM Page 4

ASSEMBLY INSTRUCTIONS

Step 1 Step 2
Attach the handle
to the frame of the pressure
gun/hose storage handle.
washer. Align holes, insert
bolts, and tighten with knobs.
Step 4 Step 5
Place the quick
3
connect nozzles in the wand to the spray gun.
nozzle holder.
Step 7 Step 8
Release the collar
and push the nozzle until the high pressure hose to the
collar clicks. Pull the nozzle to spray gun.
make sure it is seated properly.
Important!
Do not run the engine with a high or low oil level as
this can cause engine damage. If you have further
questions regarding the engine, please refer to the
engine's operating manual included with the unit.
Step 10
Connect the
garden hose to unit's
water inlet.
Step 3
Attach the Attach the reel
to the handle. Align holes,
insert bolts, and tighten
with nuts.
Step 6
Attach the Pull the spring-
loaded collar of the wand
back to insert your choice
of quick connect nozzle.
Step 9
Attach the Connect the
high pressure hose to the
unit's high pressure outlet.

OPERATING INSTRUCTIONS

Step 1
Check oil level. Oil level should be level
with the bottom of the oil filler neck. Be sure the
machine is level when checking the oil level. (Refer to
the engine's operating manual for seasonal grades.)
We recommend that the oil be changed after the first
5 hours of use, then once every 50 hours.
Note: Improper oil levels will cause low oil sensor
to shut off engine.
Step 4 Step 5
Trigger the gun Slide the choke
to eliminate trapped air, wait lever to the left to the "CLOSED"
for a steady flow of water to position (on a warm engine, leave
emerge from the spray the choke lever in the open
nozzle. position).
Step 7 Step 8
Turn the engine Pull the starter
switch to the "ON" position. handle. If the engine fails to
start after 3 pulls, squeeze
the trigger gun to release
pressure, and repeat step.
After the engine is warm and
running smoothly, slide the
choke lever to the right (open)
and throttle to the left (fast).
Step 2 Step 3
Fill gas tank Connect garden
with unleaded hose to the cold
gasoline. water source
Do not use
and turn water
leaded gasoline. on completely.
Never use hot
water.
4
Step 6
Slide the fuel
valve to the "ON" position.
Slide the throttle lever left
about 1/3 of the way toward
the fast position.
Step 9
Adjust pressure
control to desired setting.