Optional Cleaning Accessories - Kärcher HD 3000 Operator's Manual

HD3000 Manual 9/20/02 5:28 PM Page 10
CLEANING TIPS
– continued
Barbeque Grills, Outdoor
Power Equipment &
Gardening Tools
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher All Purpose Cleaner or
Degreaser, place detergent suction tube
directly into cleaning solution and apply
detergent at low pressure. Allow Kärcher
detergent to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure keeping the spray
nozzle approximately 3-6 inches from the
cleaning surface. For removing extremely
stubborn dirt, it may be necessary to move
the spray nozzle even closer to the surface
for greater dirt cutting action. To remove
caked on mud from garbage cans, lawn
mower blades, wheelbarrows or other
non-sensitive metal surfaces, you may
want to use the Kärcher Dirtblaster ® Nozzle.
Caution: Do not use Dirtblaster ® spray
9
nozzle on cloth, plastic or other sensitive
surfaces as it may cause damage.

OPTIONAL CLEANING ACCESSORIES

Optional cleaning accessories are available to further enhance your cleaning capabilities.
See accessories order form for product descriptions and ordering instructions.
• Dirtblaster ® nozzle
• Extension Wand 80"
• Rotating Wash Brush
• Sand Blasting Attachment
USA: 1-800-537-4129
www.karcher-usa.com
CAN: 1-800-465-4980
www.karcher.ca
Patio & Lawn Furniture
(with or without detergent)
Pre-rinse furniture and surrounding area with
fresh water. If using Kärcher All Purpose
Cleaner, place detergent suction tube direct-
ly into cleaning solution and apply to surface
at low pressure. Allow Kärcher All Purpose
Cleaner to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure in a sweeping motion
keeping the spray nozzle approximately 3-6
inches from the cleaning surface. For best
results, clean from top to bottom and from
left to right.
Caution: Do not use Dirtblaster ® nozzle on
patio or lawn furniture as it may cause
damage.
Recommendations
• Before cleaning any surface an inconspic-
uous area should be cleaned to test spray
pattern and distance for maximum clean-
ing results.
• If painted surfaces are pealing or chipping,
use extreme caution as pressure washer
may remove the loose paint from the
surface.
• Hose Reel
• Pipe Drain Cleaner
• Extension Hose 30'
• Detergent Tray
TROUBLESHOOTING
Symptom Cause
Engine will not start. No gasoline.
Low oil level sensor activated.
Fuel valve is in "OFF" position.
Engine throttle is not in
correct position.
Choke is not in correct position. Slide choke lever left to "CLOSED" position.
Pressure built up in the
high pressure washer.
Engine switch in "OFF" position. Turn engine switch "ON".
Unit does not reach Diameter of garden hose
high pressure. is too small.
Water supply is restricted.
Not enough inlet water supply.
Water inlet filter is clogged.
Pump pressure control is in
low pressure position.
Black detergent nozzle
is attached.
Output pressure varies Not enough inlet water supply.
high and low.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle
is obstructed.
Calcified gun, hose
or spray wand.
Solution
Fill gas tank.
Add oil.
Slide the fuel valve lever to "ON" position.
Slide the throttle left 1/3 of the way
to the fast position.
Squeeze the trigger to release
the pressure.
Replace with a 3/4 inch
garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source full force.
10
Remove filter and rinse out
in warm water.
Turn pump pressure control to high
pressure position.
Remove black detergent nozzle and
attach a high pressure nozzle.
Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until
a steady flow of water emerges
through the nozzle.
Remove filter and rinse out
in warm water.
Blow out or remove debris
with a fine needle.
Run distilled vinegar through
detergent suction tube.