Inspection And Maintenance - REMEHA Avanta Range 24c Installation & Service Manual

3 INSPECTION AND MAINTENANCE

fi g. 49 Annual inspection
112952.LT.GB.W7H.053
The Remeha Avanta Plus is practically maintenance free but
should be inspected annually.

If during the annual inspection the flue gas analysis indicates
that the values are outside the figures given in table 11, main-
tenance work should be carried out as described in par.3.2.
Also carry out maintenance if the ionisation read-out value is
lower than 3 or higher than 9μA.
Only Remeha spare parts/materials should be used.
All service and maintenance must be carried out by a qualified
Engineer with the relevant training and certification (i.e. ACS
- IEE registrations etc).
3.1 Inspection
The annual inspection of the Remeha Avanta Plus can be lim-
ited to the following checks:
- check the water pressure, see par. 3.1.1;
- check the flue pipes and air supply pipes for leaks, see par.
3.1.2.;
- check and clean (if necessary) the condensate siphon, see
par.0.;
- check the ignition electrode and ionisation, see par. 0;
- check the combustion and flame pattern, see par. 3.1.5;
- Fill in the Benchmark Service Record on the inside back
pages of this document.
> 1 bar
43