Video Input Signals; Video Encoding Modes - Barco MDCG-10130 User Manual

5.19 Video input signals

Your Coronis Fusion 10MP display automatically detects the connected video input sig-
nals. Manually selecting image source video input signals is possible, but then your
display's image source selection mode should be set to allow this. Please refer to "Im-
age source selection modes", page 26 to do this.
About input signals
The available input signals for your display are:
DisplayPort 1
DVI 1
DisplayPort 2
DVI 2
Automatic Selection
To manually select a video input signal:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > (Left/Right) Image Source menu.
3. Enter the Input Signal submenu.
4. Select one of the available input signals and confirm.

5.20 Video encoding modes

Your Coronis Fusion 10MP display automatically detects the connected video input sig-
nals and applies the correct video encoding settings. Manually selecting a video encod-
ing mode is possible, but then your display's image source selection mode should be
set to allow this. Please refer to "Image source selection modes", page 26 to do this.
About video encoding modes
Video encoding modes specify how the color and luminance information is encoded in the video signal.
In consumer displays, this is usually done by a limited 8-bit encoding mechanism. Your Coronis Fusion
10MP however, features 10-bit encoding enabling it to better match the DICOM defined grayscale range.
Such an extensive range is necessary to comply with the guidelines set forward by the latest medical
guidelines.
The available video encoding modes for your display are listed below.
Please note that the display controller connected to your display might not always sup-
port all these video encoding modes.
Standard
HDR1
K5902031 CORONIS FUSION 10MP 28/08/2013
The input corresponding to the DisplayPort 1
connector.
The input corresponding to the DVI 1 connector.
The input corresponding to the DisplayPort 2
connector.
The input corresponding to the DVI 2 connector.
The input is automatically selected.
This mode uses the standard 8 bit encoding
mechanism.
This mode features 10-bit video encoding following
the High Dynamic Range (HDR) standard, usually
used on color displays.
5. Advanced operation
27