Installation; Supplementary Furnace - St. Croix SCF-Revolution Installation & Operation Manual

Multi-fuel furnace
Table of Contents

Advertisement

i. Do Not Burn Garbage, Gasoline, Naphtha, Engine Oil, or Other Inappropriate
Materials
j. The Furnace will not operate during a power failure, unless a Battery Back-up
system is used during brief power outages. Prolonged Power Outages will require
the use of a Generator to operate the Furnace.
Additional Canadian Requirements for Supplementary (Add-On) Furnaces.
(See label on the inside front panel of the furnace for additional information)
1.
DO NOT USE DUCT ELBOWS HAVING AN INSIDE RADIUS OF LESS THAN
6"(150mm) ON THE FURNACES.
2.
DO NOT CONNECT DUCTWORKSO THAT A REVERSE FLOW IS POSSIBLE.
3.
OPERATE THE (GAS, OIL OR ELECTRIC) FURNACE PERIODICALLY TO
ENSURE THAT IT WILL OPERATE SATISFACTORILY WHEN NEEDED.
4.
CERTIFIED FOR INSTALLATIOS WITH DUCT WORK CONFIGURATIONS
SIMILAR TO THAT SHOWN IN FIGURE 8 ON PAGE 18.
5.
DO NOT RELOCATE OR BYPASS ANY OF THE SAFETY CONTROLS IN THE
ORIGINAL (GAS, OIL OR ELECTRIC) FURNACE INSTALLATION.
6.
DO NOT CONNECT WITH ANY GAS FURNACE THAT HAS NOT BEEN
CERTIFIED INITIALLY AS COMPLYING WITH CAN/CGA-2.3
7.
THE OPERATION OF THE GAS FURNACE MUST BE VERIFIED FOR
ACCEPTABLE OPERATION BEFORE AND AFTER INSTALLATION OF THIS
ADD-ON FURNACE BY A GAS FITTER WHO IS RECOGNIZED BY THE
REGULATORY AUTHORITY.
8.
DO NOT CONNECT TO ANY GAS FURNACE THAT IS NOT EQUIPPED WITH
A AN AIR-CIRCULATING BLOWER, OR TO A CHIMNEY OR VENT SERVING
A GAS FURNACE OR APPLIANCE.
9.
This furnace should only be installed on a furnace duct system and chimney that are
in good operating condition.
10.
This furnace is equipped with a direct drive blower motor. This motor should not be
changed with one of lesser speed. A motor with a faster speed may be used. The size
of the blower should not be changed. This equipment should be installed, acceptable
to regulatory authority, by experienced licensed personnel.
11.
The installation of this furnace should comply with the requirements of CAN/CSA-
b365. and changes to the installation should comply with CSA B139 (for oil fired),
C22.1 (for electric), or CAN/CGA-B149.2 (for gas fired).
SCF-Revolution Manual
52

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents