St. Croix SCF-Revolution Installation & Operation Manual page 25

Revolution Multi-Fuel Pot - Removal
Figure 14
1 – LINE THE COUPLING BOLT UP WITH THE HEX HEAD OF THE BOLT IN THE UPWARD
POSITION BY TRIPPING THE SWITCH CONTROLLING THE REVOLUTION MOTOR. (See
figure 14)
2 – Remove the Igniter cover and Igniter. (See figure 13)
3 – Remove the cover on the left side covering the revolution motor. Remove the 2 screws that hold
the Revolution Switch & Bracket in place. Remove the 4 screw that hold the Revolution motor in
place. Pull the motor back about ½". This will disengage the drive coupling from the burn pot. (See
figure 14)
4 – Remove the side shields. (See figure 13)
5 – Remove the screw that holds the burnpot in place and lift the burnpot up and out of the stove. (See
figure 13)
6 – Reverse steps to re-install the Revolution pot.
SCF-Revolution Manual
25