Installation And Wiring - Braeburn 3020 Detailed Installer Manual

2 Installation and Wiring

Warning
Thermostat Location
Install the thermostat approximately 5 feet (1.5m) above the floor in an area that has a good amount of air
circulation and maintains an average room temperature.
Avoid installation in locations where the thermostat can be affected by drafts, dead air spots, hot or cold air
ducts, sunlight, appliances, concealed pipes, chimneys and outside walls.
Install your new Braeburn thermostat in 4 basic steps:
1 Install the Sub-Base
2 Provide Power
3 Connect Your Wires
4 Attach Thermostat to Sub-Base
1
Install the Sub-Base:
• Remove the sub-base from the body of the thermostat.
• Mount the sub-base as shown below:
Installer Guide
Disconnect power before beginning installation.
Drill 3/16" pilot holes in your
desired location. Use supplied
anchors for drywall or plaster.
UP
2
UP