Connecting The D340 Ergoline Terminal - Philips ErgoLine D330 Manual

ErgoLine D330/D340
Customer Engineer Manual
6. Press Shift, Hold.
The following display will appear on the screen:
[ Scroll, OK accept]
Clear All Keys?
7. Scroll down until the Set TEI option is displayed and press OK key.
The following display will appear on the screen:
[Enter 0 or 1, OK]
TEI:0
8. Enter 0 or 1 to change the TEI number, then press the OK key to accept the
new setting.
The following display will appear on the screen:
TEI Set!
Note: This display will be shown only for a few seconds.
Note: The TEI must be granted by the network. If the TEI is not supported, the
display will show the message TEI Denied indicating that another terminal
already occupies the specified TEI i.d. The terminal TEI i.d. needs to be changed
to a unique value before it will be accepted.
If the set remains non-operational after setting the TEI, the message TEI Denied
can be displayed by pressing the down arrow key.
Note: If the TEI has been changed it is necessary to remove and re-insert the line
cord for the change to take effect.

Connecting the D340 ErgoLine Terminal

The D340 ErgoLine terminal is connected as follows:
1. Connect the handset cord to the handset port on the underside of the
ErgoLine terminal and put the handset on the cradle.
2. Connect the data terminal to the V.24 data port.
3. Connect any other equipment to the appropriate connectors as necessary:
• PC interface
• Audio interface
• Static interface
4. Connect the mains plug transformer to the mains supply (only for mains
powered terminals). The idle menu will be on the display.
5. Connect the telephone line cord to the line port on the underside of the
ErgoLine terminal.
6. Plug in the telephone line cord at the PNT1 or the wall socket.
Page 2-8
↓