Pc Interface Option - Philips ErgoLine D330 Manual

PC Interface Option

The PC Interface is standard on the ErgoLine D330 and D340. This PC interface is
used for driving the terminal via a PC allowing TAPI-compliant applications to be
used via this interface.
Connection to the PC Interface is via a 9 pin D-type female connector on the
rear of the ErgoLine main terminal unit.
F
IGURE
T
ABLE
9-Way Terminal
Pin 2
Pin 3
Pin 5
Software Installation
A TAPI software driver will be provided on 3.5 inch floppy disk, enabling TAPI-
compliant applications to be used via the interface. The TAPI driver is compatible
with Windows 3.1, Windows 3.11 and Windows 95.
To install the software, connect the ErgoLine terminal to your PC via the PC
Interface using a one to one cable. Install the software on the PC as follows:
Windows 95:
1. Insert the floppy disk into the disk drive.
2. In Windows 95, click Start then Run.
3. Type in A:\setup, then press the return key.
4. Follow the on-screen instructions to complete the software installation.
Windows 3.1/3.11
1. Insert the floppy disk into the disk drive.
2. From Program Manager select File/Run.
3. Type in A:\setup in the dialog box, then press the return key.
4. Follow the on-screen instructions to complete the software installation.
6
1
2-7. PC I C
NTERFACE ONNECTOR
2-16. PC I C
NTERFACE ABLE
9-Way PC
Pin 2
Pin 3
Pin 5
ErgoLine D330/D340
Customer Engineer Manual
9
5
P L
IN AYOUT
P C
IN ONFIGURATION
25-Way PC
Pin 3
Pin 2
Pin 7
Page 2-39