Sartorius Basic Series Installation And Operating Instructions Manual page 17

After you have accessed the menu of the balance operating
program, the display will show a continuous sequence of num-
bers from 0-5 for the "page" or first digit of the code, in addition
to the Status code letter "L" or "C."
When the first digit of the code you wish to check or change ap-
pears, press the tare control (13).
st
The "page" code number (1 digit) now stops in the display, and
nd
a series of numbers for the 2 digit or "line" will begin to cycle.
Press the tare control again to stop the code number of your
choice in the display. Next, the numbers for the "word" (last
digit) will cycle in the display. Repeat the procedure to enter
the last digit of the code.
The "o" symbol that appears indicates the actual setting.
To change any menu code settings ("C" mode), press the tare
control as soon as the appropriate code is displayed.
Brief display of BUSY and the "o" symbol confirms you selec-
nd
tion, followed by a return to "zero" for the 2 digit or "line."
How to return to the weighing mode:
Press the tare control each time a "0" appears in the numerical
sequence (word, line, page). lf you have changed a menu code,
it will be stored as soon as the display returns to the weighing
mode. Lock the balance operating program using the menu ac-
cess switch ("L" readout), and replace the protective cap.
Auto Zero
This balance has an automatic zero tracking function known as
"Auto Zero."
Any changes off zero ≤± 2 digits (B 120 S),
± 1 digit (B310P/S) or ± 0.5 of a digit (B410,B610, B 3100 P/S,
B4100 or B6100) per second will be automatically set to zero.
17