Cisco TelePresence EX Series Getting Started Manual page 32

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
The Settings menu on the Touch
controller
All settings are not available on all products; therefore the
menu items shown to the right may or may not be present on
your system.
You will find a complete description of the Touch controller
menus in the User guide for your video conference system.
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration
Settings
System Information
Call Status
Language
Camera Control & Settings
Display Settings
Ringtone & Sound Settings
Background
Main Source Selection
Administrator Settings
Restart
Back
| Administrator Sett
Date, Time & Location
Call Settings
Network Settings
Web Snapshots
EMC Resilience Mode
Reset
IP & VLAN
Pairing
H323 Settings
SIP Settings
Provisioning
Multiway
Appendices Appendices
The Settings menu
• System Information: See and overview of the system configurations.
• Call Status: See an overview of the call parameters when in call (e.g. protocols,
transmit and receive rates, packet loss).
• Language: Select the language for the user interface.
• Camera Control & Settings: Set the camera parameters.
• Display Settings: Select brightness, color temperature and DVI mode for the
main video display.
• Ringtone & Sound Settings: Select a ring tone, the ring tone volume and key tone.
• Background: Select a background picture for your Touch controller and main
video display.
• Main Source Selection: Select the main input source, e.g. camera control.
• Administrator Settings: See below.
• Restart: Select this option to restart the system.
The Administrator Settings menu
• Date, Time & Location:
• Call Settings: Configure the default bit rate and auto answer settings.
• Network Settings:
• Web Snapshots:
• EMC Resilience Mode:
controller's resilience to electromagnetic noise present.
• Reset: Select this option for a complete factory reset. All your settings
will be reset.
Back
| Network Settings
The Network Settings menu
•
IP & VLAN: Configure the IP and VLAN settings. If the
Touch controller is connected via LAN there will be
separate entries for the codec and the Touch.
• Pairing:
Touch controller.
• H323 Settings:
• SIP settings: Configure the SIP settings.
• Provisioning:
• Multiway:
Configure date and time settings.
See below.
Allow/Disallow the web snapshot feature.
Select this option to change the Touch
Configure pairing between the codec and the
Configure the H.323 settings.
Start the provisioning wizard.
Insert the address of the Multiway server.
www.cisco.com
32