Cisco TelePresence EX Series Getting Started Manual page 11

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Configuration tasks (continued)
Setting the IP parameters
(when not set by a provisioning system)
Your video conference system must be connected to
an IP network. Both IP version 4 (IPv4) and IP version 6
(IPv6) are supported. In both cases, the IP parameters
can be assigned automatically by the network, or you can
set everything manually.
Choose one of the following methods to set the IP
parameters:
Touch controller
Remote control and
on screen menu
Web interface
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces
Setting the H.323 and SIP parameters
(when not set by a provisioning system)
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use
either the H.323 protocol or the SIP protocol for video
calls.
Choose one of the following methods to set the H.323
and SIP parameters:
Read more... Touch controller
Remote control and
Read more...
on screen menu
Read more... Web interface
Configuration Configuration Appendices
Read more...
Read more...
Read more...
Setting date and time
(when not set by a provisioning system)
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
Choose on of the following methods to set the codec
password:
Touch controller
Remote control and
on screen menu
Web interface
11
Read more...
Read more...
Read more...
www.cisco.com