Cisco TelePresence EX Series Getting Started Manual page 12

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
touch controller
Configuration using the Touch controller
Waking up the system
If no menu is displayed on the Touch controller, tap the
display to wake up the system.
If the system does not wake up:
• Make sure the Touch controller is connected to the main
unit.
• Make sure the main unit is connected to power and
switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
If in doubt, read the Installation guide for your product.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration Appendices
Touch controller
12
www.cisco.com