Cisco TelePresence EX Series Getting Started Manual page 26

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Web interface
Configuring IP
(when not set by a provisioning system)
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you will
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to the Diagnostics tab and select
The system's IP address is listed in the General section.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces
1. Select IP version
Go to the Configuration
Configuration.
Open the Network 1
which IP version to use in the
2. Select automatic or manual IP assignment
For IPv4: Select
down list.
For IPv6: Scroll down the page to the
select Autoconf
list.
System Information.
IPStack
IPv4
IPv6
Configuration Configuration Appendices
tab and select Advanced
settings from the left column. Select
IPStack drop down list.
DHCP or Static in the Assignment drop
IPv6 section and
or Static in the Assignment drop down
DHCP/Autoconf
The IP configuration is complete.
a. Select On or Off in the DHCPOptions
down list according to your preference.
DHCP Options:
1
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
3. Set the IP addresses
Set the remaining IP settings according to the table
below. The actions required depend on the IP version
(IPStack) and IP assignment method (Assignment) you
selected in the previous steps.
Assignment
Static
a. Under the heading IPv4; enter the
Address, Gateway and SubnetMask
corresponding input fields. Click
the change.
b. Under the heading DNS, enter the DNS
server address in the Server 1 Address
field. Click ok to save the change.
drop a. Select On or Off in the DHCPOptions
down list according to your preference.
1
b. Enter the system IP address in the
input field and the gateway address in the
Gateway input field. Click
change.
26
in the
ok to save
input
drop
1
Address
ok to save the
www.cisco.com