Download Print this page

Cisco TelePresence EX Series Getting Started Manual page 17

Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems
Hide thumbs Also See for TelePresence EX Series:

Advertisement

Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
remote control and on-screen menu
Configuration using the remote control and on-screen menu
Waking up the system
If there is no menu on screen, press
Home
remote control to show the menu.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been
switched on.
• Make sure the remote control has the batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
If there is still no menu on screen, make sure the monitor
cable is connected to the basic video output connector. If in
doubt, see the Installation guide for your product.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces
(
)
on the
Configuration
Configuration
Appendices
Remote control and
on-screen menu
17
www.cisco.com

Advertisement

loading