Cisco TelePresence EX Series Getting Started Manual page 16

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
touch controller
Setting date, time and location
(when not set by a provisioning system)
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
The time is shown in the top right corner of the Touch
controller display.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
1. Tap More > Settings > Administrator settings > Date,
Time & Location.
2. Tap 24h or 12h to select the
3. Tap dd.mm.yy, mm.dd.yy or yy.mm.dd
Format you prefer.
4. Select the Time Zone your system is in. Step through the
list of available zones by tapping the - or + signs.
5. Set Date & Time Mode to Auto
to be regularly updated; otherwise, select Manual.
If you select Manual, enter the correct value for Hour,
Minute, Year, Month, and Day. Tap the plus and minus
signs to increase or decrease a value.
If you select Auto, the NTP server address can be
automatically obtained from the network (set the
Mode to Auto) or you can enter the
yourself (set NTP Mode to Manual).
6. Tap Save to save the changes, or
saving.
7. Tap Exit to return to the home menu.
Appendices
Time Format you prefer.
to select the Date
if you want time and date
NTP
NTP Server address
Undo to leave without
16
www.cisco.com