Wall Station Operation; Transmitter Operation - Wayne-Dalton Optimal Installation, User Operation & Maintenance Manual

WALL STATION OPERATION

Momentarily pressing up/down button (2d) activates the door. If a small out-of-balance condition causes door to stop while opening or
reverse while closing, apply constant pressure to up/down button until door is fully opened or fully closed. Problem must be corrected
immediately, see Troubleshooting Section on page 20.
Momentarily pressing light button (1z) turns on light fixture. The light fixture will remain on until either light button is pressed again or
the door is activated. The light fixture automatically turns on with door activation and remains on for five minutes thereafter. Pressing
light fixture button before five minutes has elapsed will turn off light fixture.
Momentarily pressing timer button (2l) causes the light fixture to light for a period of five minutes. During this time, the light can be
turned off by pressing the light button (2l). If the door is activated during the time the light is on, the light timer is turned off and the
standard five-minute timer for the light now takes effect.
Pressing pet button (2h) activates a closed door and causes it to open to a position between 200 mm and 750 mm above floor,
allowing pets to enter and exit the garage without door being fully open. The next door activation will cause door to open fully. The pet
feature will only function with door in fully closed position. Pressing pet button with a stationary door in any other position will cause
opener to beep five times and door will not be activated. While door is in motion, pet button functions identically to up/down button,
stopping or reversing door immediately. The pet feature allows for custom setting of pet position door height. See Custom Settings,
Step 13.
NOTE: A door in the "pet position" (open 200 mm – 750 mm) is not locked and should not be used as a secured door position.
Press and hold the profile button (2c) for about 5 seconds to initiate the "Install Routine". Refer to Step 10: Install Routine for
complete install routine instructions, functions and warnings. The door should be completely closed to initiate the install routine. The
only exception to this is if a custom upper limit is being set (see Step 10).
The Wall Station LED (2a) will light while any wall station button remains pressed. if the LED does not light, this is an indication that the battery is weak or
dead. See maintenance, battery replacement.
NOTE: The opener can be activated by up to six remote control devices (including Wall Station and keyless entry controls.) If a seventh control is
programmed, one of programmed controls will be erased and will no longer activate the opener.
WARNING
FOR SAFETY REASONS, MANUALLY DISCONNECT USING THE EMERGENCY DISCONNECT HANDLE PRIOR TO
ERASING REMOTE CONTROLS.
Momentarily pressing the large transmitter button (2e) or the button programmed in the transmitter programming step activates the door. Other
transmitter buttons can also be programmed to activate a door, or multi-door installations, each button or a combination of two buttons pressed
simultaneously can be programmed to activate a different door. See Transmitter programming (refer to step 11) for instructions.
The transmitter LED (2f) will light while any transmitter button remains pressed. if the LED does not light, this is an indication that the battery is weak or
dead. See maintenance section for battery replacement.
WALL STATION OPERATION (IF SUPPLIED).

TRANSMITTER OPERATION

14