Effect Wheel; Gobo Animation - Martin MAC 2000 Performance II User Manual

Effect wheel

The effect wheel provides a variable frost filter and two positions for effects. The MAC 2000 Performance II comes
with a wide angle lens and a nine-fact prism installed in these positions.
Wide angle lens
(beam expander)
Variable frost filter
Replacing effects
1 Disconnect the fixture from power and allow it to cool.
2 Lock the head in the upside down position and remove the bottom cover. Turn the effect wheel so that the
locking plate is under the sensor bracket.
3 To remove, hold the rim of the effect holder and pull back on the locking plate. Remove effect from wheel.
4 To insert, pull back on the locking plate. If both effects are removed, pull straight back on both tabs. Position
the groove in the effect holder over the fixed plate. Release the locking plate and verify that the effect is
properly seated.
5 Replace the bottom cover and unlock the head before operating.
Locking plate

Gobo animation

The following gobo animation wheel patterns are supplied with the MAC 2000 Performance II.
DHA 11
Tangential breakup
34
DHA 12 (installed) DHA 13
Spiral breakup
Radial breakup
MAC 2000 Performance II
9-facet prism
Open position
Position the effect holder
groove over the fixed plate.
DHA 16 DHA 18
Cloud breakup Dot breakup