Martin MAC 2000 Performance II User Manual page 35

For information about using the gobo animation effects, see "Animation guide" on page 21.
R e p l a c i n g t h e g o b o a n i m a t i o n w h e e l
1 Disconnect the fixture from power and allow it to cool.
2 Lock the head in the upside down position and remove the bottom cover.
3 Using a finger or thumb (as illustrated), move the installed animation wheel up.
4 The animation wheels are made of thin aluminum, so use a screw driver to release the wheel from the
magnetic mount.
5 Take the wheel out by hand.
6 To insert a new wheel, place it over the mount, ensuring that the magnet that is fitted to the animation wheel
is facing the mount. There is a small indexing position hole in each animation wheel and the indexing pin on
the mount must be positioned in this hole.
7 Replace the bottom cover and unlock the head before operating
Optical configuration 35