Glass Ceramic Hob Control Elements - Kleenmaid CH805CE-1 Instructions For Use Manual

Glass ceramic hob control elements

Switching the hob on
8
172731_en.indd 8 172731_en.indd 8
• Once the glass ceramic hob is connected to the mains
(including the power failure), the appliance carries out the
harmonization with the conditions of the exterior in order to
provide most effi cient sensor function and render the best
control environment.
• After the successful accommodation to the environment, the
indicators show the mark "-" for a moment which eventually
disappear. The sound signal confi rms the appliance is ready
for use.
• Do not place any objects upon the sensor surface during
the accommodation period, otherwise you may provoke
error mode. In such cases the process is interrupted and the
appliance signals error. The hob fails to respond to commands.
• The hob is equipped with electronic sensors which are
switched on by touching or pressing the sensor surface with
your fi ngertip. Each sensor reaction is confi rmed by the beep.
• Always take care to touch only one sensor at the time for a
short period of time (approximately 1 second). If more than
one sensor is pressed at the same time the relevant command
is not accepted. If the touch is prolonged it provokes error
mode and the appliance is switched off.
• Do not place any objects upon the sensor surface (error mode)
nor any hot dishes which may damage the sensors. Keep the
sensor surface clean at all times.
• When the hob is turned off all the hotplates are off and
indicator LED's are off.
• To switch the hob on, touch the ON/OFF sensor. The hob is
activated and all power displays indicate "0" for a period of
10 seconds. Using the (+) or (-) sensor you may select the
desired cooking power of a particular hotplate (see Power
Regulation).
• Next setting of a particular hotplate should be selected within
ten seconds, otherwise the hob will automatically be switched
off and a short warning beep is heard.
9.1.2007 14:52:02 9.1.2007 14:52:02