Chute Assembly - Power smart DB7653 User Manual

Auger Control Cable Attachment
1. With the upper handle in the down position,
connect the auger control cable to the auger
control handle.
Note: Connect the auger control cable to the
lower hole first. Connect the cable into the
upper hole if the auger does not turn upon
startup when the auger control handle is
pulled. The upper hole allows the cable to
apply more tension on the auger drive belt.

Chute Assembly

1. Unfasten and remove the locking collar from
the base of the discharge chute.
Note: Check to make sure the chute detent
spring clip is in position on the chute base.
2. Align and install the discharge chute onto the
chute base.
3. While holding the chute assembly in position,
install the locking collar to secure the chute to
the chute base.
4. Note: The hole on each of the locking collar
must be in the front of the discharge chute.
8