Integrated Antenna Model Suspended Ceiling T-Bar Mount Instructions; Suspended Ceiling Mount Procedure - Motorola AP6532 Installation Manual

Installation Guide
2. Using the arrows on one edge of the case as guides, move the edge to the midline of the mounting area
and mark points on the midline for the screws.
3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting screw and
stop when there is 1mm between the screw head and the wall.
NOTE
4. If required, install and attach a security cable to the unit's lock port.
5. Attach the Ethernet cable to the unit and to a controller with an 802.3af-compatible power source.
6. Place the middle of each of the case's mount slots over the screw heads.
7. Slide the case down along the mounting surface to hang the mount slots on the screw heads.
8. Verify the unit has power by observing that the LEDs are lit or flashing.

2.5 Integrated Antenna Model Suspended Ceiling T-Bar Mount Instructions

Ceiling mount requires holding the AP6532 Access Point up against a T-bar of a suspended ceiling grid and twisting
the case onto the T-bar.

2.5.1 Suspended Ceiling Mount Procedure

1. If required, install and attach a security cable to the unit's lock port.
When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if
the screws are going directly into the wall and 6mm (0.23in.) if the
provided wall anchors are being used.
11