Handling Note; Checking The Throttle Position Sensor Coil; Changing And Adjusting The Throttle Position Sensor - Yamaha YZ250 2022 Owner's Service Manual

EAM30587

HANDLING NOTE

ECA27120
NOTICE
Do not loosen the screw (throttle position
sensor) "1" except when changing the throt-
tle position sensor due to failure because it
will cause a drop in engine performance.
EAM30588
CHECKING THE THROTTLE POSITION
SENSOR COIL
1. Remove:
• Carburetor
• Mixing chamber top
Refer to "CARBURETOR" on page 7-3.
2. Check:
• Throttle position sensor coil resistance
Out of specification  Replace.
• Positive tester probe 
Blue "1"
• Negative tester probe 
Black "2"
Throttle position sensor coil re-
sistance
4–6 k
3. Check:
• Throttle position sensor coil variable resis-
tance
Check that the resistance in increased as the
lever "1" is moved from the full close position
ELECTRICAL COMPONENTS
to the full open position.
Out of specification  Replace.
• Positive tester probe 
Yellow "2"
• Negative tester probe 
Black "3"
Throttle position sensor coil vari-
able resistance
Full closed
0–2 k
Full opened
4–6 k
EAM30589
CHANGING AND ADJUSTING THE
THROTTLE POSITION SENSOR
1. Remove:
• Carburetor
• Mixing chamber top
Refer to "CARBURETOR" on page 7-3.
2. Remove:
• Screw (throttle position sensor) "1"
• Throttle position sensor "2"
TIP
Loosen the screw (throttle position sensor) using
the T25 bit.
3. Replace:
• Throttle position sensor
4. Install:
• Throttle position sensor "1"
• Screw (throttle position sensor) "2"
8-11