Table of Contents
Advertisement
6.4.1
INSTALLATION OF REMOTE PANEL WITHOUT E.P.O.
To install this board please follows the procedures below.
Make sure that the U.P.S. is off and that all the switches are off (if the U.P.S. is already
operative please proceed to by-pass setting chapter 5)
Unscrew the set screws from the second access panel of the U.P.S. and remove it.
Check if there is an interface board (picture 20); (present only if requested before
purchase). Its position varies according to the different models but it is always viewable
and accessible by the user.
Picture 20
If there is a board please go directly over, otherwise continue with the following procedures.
Insert the four supports for the printed circuit in the holes as specified (picture 21).
Picture 21
EVO STAR 10-50
40
Tecnoware Power Systems
Advertisement
Table of Contents
