Table of Contents
Advertisement
Tecnoware Power Systems
6.3 P.C. INTERFACE
.
The U.P.S is supplied with a communication interface, which allows signal exchanging with
external equipment.
The interface output is a serial port, which transmits to the RS232 system. The communication
protocol is compatible with Generex and Megatech U.P.S. management software.
Furthermore, other types of interfaces are available by using adapters, such as:
SNMP communication port to connect the U.P.S. to the mains
USB communication port to connect Plug & Play to a PC
RS485 serial communication port (half-duplex or full-duplex)
Through integrating with server and enterprise management platforms SNMP (Simple Network
Managing Protocol), or even via web, you can control remote management. Inserting the
U.P.S. in LAN/WAN, with the usual "Ethernet" connection (available as optional interface
through the RS232 port), it is possible to treat it like any other network element with its own
IP address with which all the other pieces of equipment on the network can have advanced
communication.
6.4 REMOTE PANEL (optional)
The remote panel is an extension of the synoptic supervision (picture 17 plus chart 1); this is
particularly useful when you need to monitor machine functioning in a remote place.
Furthermore, it is possible to supply it with an E.P.O. switch (chapter 4.2.1). This device is
composed of two main parts, one interface board inside the machine and an actual synoptic
which should be installed in a place of your choice to carry out monitoring at a maximum
distance of 25 meters.
The synoptic is in a wall box with a bottom cable passage.
Please remember that the remote panel needs a 220-240V/50-60Hz power supply, which is to
be taken only from the U.P.S. output.
A specialized technician is recommended to install these devices.
Picture 19
Please refer to picture 6 for the meaning of the state of the leds.
EVO STAR 10-50
39
Advertisement
Table of Contents
