Load Fail-Safe Default; Load Optimized Default; Password Setup - Korenix JetBox 8100 User Manual

In this commands, you can monitor or detect the following items. These
items are view only and can't be changed.
CPU Vcore
+2.500V
+3.300V
+5.000V
VBAT(V)*
CPU Temperature
System Temperature
* VBAT: On board Battery

4.10 Load Fail-Safe Default

To configure the system in Fail-Safe mode with predefined values.

4.11 Load Optimized Default

To auto configure the system according to optimal setting with
pre-defined values. This is also the factory default setting of the system
when you receive the product.

4.12 Password Setup

There are two security passwords: Supervisor and User. Supervisor is a
privileged person that can change the user password from the BIOS.
According to the default setting, both access passwords are not set up
and are only valid after you set the password from the BIOS.
To set the password, please complete the following steps.
1. Select Change Supervisor Password.
2. Type the desired password(up to 8 character length) when you see
the message, "Enter New Supervisor Password".
3. Then you can go on to set a user password(up to 8 character length) if
required. Note that you cannot configure the password until the
Supervisor password is set up.
4. Point to Save Settings and Exit and press Enter.
JetBox 8100 User Manual_HW_1.00
25