Installing The 2.5" Hard Driver Disk (Hdd) - Korenix JetBox 8100 User Manual

Note: The Compact Flash socket supports 3.3V Compact Flash and Micro
Drives. The JP1 is used to select master/slave device of this socket and
default is slave (close). Be sure to avoid the same master/slave setting
with which connects to IDE connector, if you use CF and IDE hard disk
simultaneous.

3.6 Installing the 2.5" Hard Driver Disk (HDD)

You can attach one enhanced Integrated Device Electronics(IDE)hard disk
driver to the JetBox 8100's internal controller which uses a IDE slot. The
advanced IDE controller supports faster data transfer. The following are
instructions of installation:
1. Remove the power cord.
2. Unscrew the screws from JetBox8100.
3. Remove the cover and extension board from main board.
4. Connect the IDE flat cable to the connector on the hard disk.
5. Fixing the HDD to bottom cover by using the 4 screws stored in
accessories box.
6. Combine extension board, metal shell and Screw back all screws .
14
JetBox 8100 User Manual_HW_1.00