Machine Installation; Preparation For The Installation; Electrical Connection; Water Supply Connection - ECM Technika Instruction Manual

Australia: 230 V
US: 115 V
Japan: 100 V
Frequency:
EU: 50 Hz
UK: 50 Hz
New Zealand: 50 Hz
Australia: 50 Hz
US: 60 Hz
Japan: 50/ 60 Hz
Power:
1,200 W
Water tank: approx. 3.0 l
Size measures: w x d x h / 322 mm x 472 mm x 380 mm
Size measures
with filter holder: w x d x h / 322 mm x 580 mm x 380 mm
Weight: 23.5 kg
4

MACHINE INSTALLATION

The installation is to be carried out exclusively by qualified staff and according to the following
instructions and in compliance with valid laws.
The following chapters deal with the preparation of the machine, its electrical connection, water supply connection
and drain connection. Please note that for water tank machines, only the subchapters "Preparation of the machine"
and "Electrical connection" are relevant.

4.1 Preparation for the installation

Place the machine on an even and stable surface. You can regulate the height of the machine by
adjusting the feet of the machine.
Never place the machine on hot surfaces.

4.2 Electrical connection

Make sure that the local main supply voltage corresponds to the information given on the type
plate on the front panel of the espresso machine.
Plug the machine only into an earthed socket and do not leave it unattended.
Do not roll or bend the power cord.
Do not use an extension cord/ do not use a multiple socket.

4.3 Water supply connection

Important
Make sure that the water supply installation is connected to potable water supply with an operating
pressure ranging from 0 to 3 bar. In case of an operating pressure of more than 3 bar use a pressure
regulator.
Please note that often the pressure of the water supply varies. If the water supply pressure temporarily
exceeds 3 bar, use a pressure regulator.
Connect the water connecting hose of the machine to the water supply valve and bolt them together.
Important
The connection of the machine to the water supply and the installation of the pressure regulator is
to be carried out by expert staff.
To avoid an early calcification of the machine we recommend to use a water softener/ water filter.
Instruction manual TECHNIKA · TECHNIKA PROFI
20
ENGLISH