Resetting To The Factory Default Settings; System Requirement For Web Browser; More Information - Syscom Video 22X PTZ III NETWORK DOME CAMERA Quick Installation Manual

4.6 Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page or use the control button on the network camera, as described below:
• Using the Reset Button
Follow the instructions below to reset the network camera to the factory default settings
using the Reset Button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the lens cover.
3. Press and hold the Control Button (SW1) on the board with your finger while reconnecting
the power.
4. Keep the Control button (SW1) pressed during about 2 seconds.
5. Release the Control Button (SW1).
6. The network camera resets to factory defaults and restarts after completing the factory
reset.
7. Close the lens cover.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.

4.7 System Requirement for Web Browser

Operating System: Microsoft Windows 98, Microsoft Windows ME, Microsoft Windows 2000,
Microsoft Windows XP, or Microsoft Windows Vista
CPU: Over Pentium IV 2.4Ghz, 512MB RAM, 10GB free disk or higher
VGA: AGP, Video RAM 32MB or higher (1024x768, 24bpp or higher)

4.8 More Information

For more information, please see the Network Camera User's Manual, which is available on the
CD included in this package.
15