Table of Contents
Advertisement
3.6 Resetting to the factory default settings
To reset the Network Camera to the original factory settings, go to the Setup>System >Maintenance
web page (described in "3.5.6 System>Maintenance" of the User's Manual) or use the Reset button on
the network camera, as described below:
Follow the instructions below to reset the Network Camera to th e factory default settings using the
Reset button.
1.
Switch off the Network Camera by disconnecting the power adapter.
2.
Remove the rear cap of the camera.
3.
Press and hold the Reset button with a straightened paperclip while reconnecting the power.
3.
Keep the Reset button pressed during about 2 seconds.
4.
Release the Reset button.
5.
The network
camera
reset.
6.
Close the rear cap of the camera.
CAUTION: When performing a Factory Reset, you will lose any settings you have saved.
3.7 More Information
For mor e inf ormation, ple ase see the Network Cam era User 's Manual , which is av ailable on the CD
included in this package.
resets to factory defaults and restarts after completing the factory
11
Quick Installation Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the Full-HD IR Bullet Network Camera and is the answer not in the manual?
Questions and answers