Table of Contents
Advertisement
Quick Links
Installation and User Manual
Suitable for installation indoors and in indoor coastal areas.
The fan is suitable for installation in a pergola or outside in
a sheltered area protected from wind and rain.
CEILING FAN MUST BE INSTALLED
BY A LICENSED ELECTRICIAN
(NO OTHER PERSONS SHOULD ATTEMPT TO INSTALL THIS FAN)
*After installation, electricians must tick off all items on the
quick checklist and fill out their details towards the back of this
Installation Manual
ELECTRICIANS - TO PROTECT YOUR CUSTOMER'S WARRANTY, PLEASE READ
PAGE 2 OF THIS BOOKLET PRIOR TO THE INSTALLATION OF THIS PRODUCT.
National Warranty Line
(Only available within Australia)
Ph: 1300 360 280 (Monday to Friday from 9am to 5pm EST)
Website: www.hunterpacific.com.au (24hours, 7days)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Concept2 ecO2
Summary of Contents for Concept2 ecO2
- Page 1 Installation and User Manual Suitable for installation indoors and in indoor coastal areas. The fan is suitable for installation in a pergola or outside in a sheltered area protected from wind and rain. CEILING FAN MUST BE INSTALLED BY A LICENSED ELECTRICIAN (NO OTHER PERSONS SHOULD ATTEMPT TO INSTALL THIS FAN) *After installation, electricians must tick off all items on the quick checklist and fill out their details towards the back of this...
- Page 2 IMPORTANT INFORMATION ELECTRICIANS MUST READ PRIOR TO INSTALLATION Distributor and installer details and purchase receipts are essential for on-site warranty claims and must be presented to repair personnel. A page towards the back of this manual has been allocated to allow you to record these details. Fans and fixed wiring products must only be installed by persons who are appropriately licensed by the applicable State regulatory body.
-
Page 3: Parts List
Installation & User Manual Parts List Concept 2/ecO2 without light Hanger Bracket Fan Speed Control Ceiling Canopy Screw Bracket Mounting Screw Ball Joint Ball Joint Screw Ball Joint Down Rod Light Down Light switch Rod Pin Ceiling Canopy Screw Down Rod Short Screw Motor Housing - Concept 2 Blade —... - Page 4 132cm (52”) ecO2 with Polymer Blades Matt Black with A2338 132cm (52”) ecO2 Polymer Blades Concept 2/ecO2 Accessory Light Kit CODE CONTENTS COLOUR A2510 R7s and E27 lamp holder assemblies, glass and rim assembly* White A2512 R7s and E27 lamp holder assemblies, glass and rim assembly*...
-
Page 5: Installation Instructions
Installation & User Manual Installation Instructions (Assembling the fan) Fig. 1 Fig. 2 Ø25mm Ø1-1/8” Fig. 3 Hanger Bracket Timber Nogging Fig. 4 1. Do not attempt to operate the fan (or optional light kit) with any wall control that is not approved by Hunter Pacific for use with its fans. - Page 6 Installation & User Manual Installation Instructions (Assembling the fan) Wiring Instructions (with and without accessory light) WARNING: To comply with AS/NZS 60335.1 a Double Pole Isolation switch must be fitted in series with the supply of this product. Fig. 5 Wire colours indicative only.
- Page 7 Installation & User Manual Installation Instructions (Assembling the fan) Fig. 8 Fig. 9 Fig. 10 Reverse Direction fan will spin in FWD (Summer) Switch mode when viewed from underneath Reverse Switch Direction fan will spin in REVERSE (Winter) mode when viewed from underneath 1.
- Page 8 Installation & User Manual Accessory Light Kit — Installation Instructions Assembling the fan (E27 Lamp Holders shown) Fig. 11 Fig. 12 Fig. 13 E27 shown. Use same process for R7 Lamp Holders. Fig. 14 Fig. 15 Fig. 16 Lamps shown are for illustrative purposes only.
- Page 9 Installation & User Manual Troubleshooting Tips for Installers - Light Light will not turn on - Make sure lamp has not blown and is properly fitted. • Check all light wires in the light kit, the terminal block in the canopy cover and the wall switch have been connected correctly.
- Page 10 Installation & User Manual Installation Instructions (Attaching an extension rod - Hunter Pacific rods to be used ONLY) Fig. 16 ≥2.1m AU/NZ Fig. 17 Fig. 18 χ Ø6.5mm χ = Holes must be in centre of rod and drilled straight through.Crooked or offset holes will cause the fan to...
- Page 11 Installation & User Manual Troubleshooting Tips for Installers - Fan Fan will not start Check that the reversing switch is fully pushed into its Summer or Winter position. • Check wire connections in the wall switch and terminal blocks, ensure all wires •...
-
Page 12: General Maintenance
Installation & User Manual General Maintenance Changing Remote Batteries: - Batteries used in Handsets will weaken over time and should be replaced every 6 months. Batteries removed from the handset should be disposed of properly and kept out of reach of children. * Always ensure fan is completely switched off at the isolation switch or circuit breaker * Cleaning the Motor Housings: - Motor housings should be regularly cleaned to avoid build up of dust. - Page 13 Installation & User Manual FORWARD (Summer) and REVERSE (Winter) Modes Explained Direction fan will spin in FWD Air is blown down, (Summer) mode when viewed from producing a cool breeze underneath FORWARD (Summer) Mode Ceiling fans are an environmentally smart choice to assist with cooling and warming your home. In FORWARD (Summer) mode your ceiling fan will spin to push air down the centre of the fan producing a cooling breeze.
-
Page 14: Quick Checklist
Installation & User Manual Quick Checklist Electricians make sure everything on this checklist is ticked off before you leave the installation site. If you have trouble installing our product please refer to the trouble shooting section on the previous page first then phone the Hunter Pacific Warranty Line on 1300 360 280 (open 9am to 5pm EST). DO NOT uninstall the fan unless asked to do so. -
Page 15: Product Details
Attach receipt here. Attach electricians invoice here. Fill out the details below and keep this manual. You will need to present your product information, installing electricians license number and proof of purchase for warranty claims. CUSTOMER DETAILS Customer Name: Installation Site Address: INSTALLING ELECTRICIAN DETAILS Electrical company and Electrician Name: License No:... -
Page 16: Warranty Terms And Conditions
Warranty Terms and Conditions Manufacturer’s warranty covers defects in the product only. It does not cover defects within the fan installation or improper maintenance. This warranty covers Australia only. Warranty periods begin from the day of purchase from an authorised reseller or dealer. Warranty on builder supplied and installed fans commences when fans are delivered to the home builder or contractor (which generally precedes hand over of the dwelling).
Need help?
Do you have a question about the ecO2 and is the answer not in the manual?
Questions and answers