Replacing A License Plate Light Bulb; Supporting The Motorcycle - Yamaha XV19CSY Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a license plate light
bulb
1. Remove the license plate light unit
by removing the nuts, washers and
rubber dampers.
1. Nut
2. Washer
3. Rubber damper
7
4. License plate light unit
2. Remove the license plate light lens
by removing the nuts and washers.
3. Remove the burnt-out bulb by pull-
ing it out.
EAU24323
1. Nut
2. Washer
3. Bulb
4. License plate light lens
4. Insert a new bulb into the socket.
5. Install the license plate light lens
by installing the washers and the
nuts.
6. Install the license plate light unit by
installing the rubber dampers,
washers and the nuts.
7-29

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
EAU24350