Yamaha XV19CSY Owner's Manual page 30

INSTRUMENT AND CONTROL FUNCTIONS
load and thereby soften the sus-
pension, turn the adjusting nut in
direction (b).
G To make the adjustment, use
the special wrench and exten-
sion bar included in the addi-
tional tool kit, which was
handed out separately at the
purchase of the vehicle.
G The spring preload setting is
determined by measuring dis-
4
tance A, shown in the illustra-
tion. The shorter distance A is,
the higher the spring preload;
the longer distance A is, the
lower the spring preload. With
each complete turn of the ad-
justing nut, distance A is
changed by 2.0 mm (0.08 in).
1. Special wrench
2. Extension bar
1. Distance A
4-14
Spring preload:
2
Minimum (hard):
Distance A = 163 mm (6.42 in)
Standard:
Distance A = 172 mm (6.77 in)
Maximum (soft):
Distance A = 172 mm (6.77 in)
3. Tighten the locknut to the specified
torque. NOTICE: Always tighten
the locknut against the adjust-
ing nut, and then tighten the
locknut to the specified torque.
[ECA10121]
Tightening torque:
Locknut:
30 Nm (3.0 m·kgf, 22 ft·lbf)
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
G
Do not tamper with or attempt to
open the cylinder assembly.
EWA10221