Yamaha XV19CSY Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
Right
4
1. Engine stop switch "
2. Light switch (for optional lights) "
3. Start switch " "
Dimmer switch "
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
TIP
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
while you are stopped at an intersec-
/ "
tion.
"
Horn switch "
EAU12400
/ "
Press this switch to sound the horn.
" for the high
Engine stop switch "
Set this switch to "
EAU12430
/ "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
". When re-
or when the throttle cable is stuck.
Light switch (for optional
lights) "
This model can be equipped with op-
tional lights available at a Yamaha
dealer.
Push this switch to the left to turn the
optional lights on and to the right to turn
them off.
NOTICE
Do not install a bulb which exceeds
12 V, 35 W in either light, otherwise
the headlight fuse may blow or the
EAU12500
" battery may discharge.
Start switch "
EAU12660
/ "
Push this switch to crank the engine
" before starting
with the starter. See page 6-1 for start-
" to
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
4-6
EAU38331
"
ECA15321
EAU12711
"
EAU41700