INSTRUMENT AND CONTROL FUNCTIONS
Auxiliary DC connector
NOTICE
The accessory connected to the
auxiliary DC connector should not
be used with the engine turned off,
and the load must never exceed 36
W (3 A), otherwise the battery may
discharge.
4
WARNING
To prevent electrical shock or short-
circuiting, make sure that the cap is
installed when the auxiliary DC con-
nector is not being used.
To access the auxiliary DC connec-
tor
1. Remove the rider seat. (See page
4-12.)
2. Unhook the battery band, and then
remove the battery cover.
EAU44583
ECA15310
1. Battery band
EWA12531
2. Battery cover
3. Turn the ECU (Electronic Control
Unit) over to move it away from the
wire harness protective cover as
shown.
2
1
1. Wire harness protective cover
2. ECU (Electronic Control Unit)
4. Open the wire harness protective
2
1
1. Auxiliary DC connector
2. Auxiliary DC connector cap
A 12-V accessory connected to the
auxiliary DC connector under the rider
seat can be used when the key is in the
"ON" position.
4-18
cover.