Copy Bc-80X0 - Datalogic PowerScan D8330 Reference Manual

POWERSCAN® D8330/M8300/M8300-DK
5.14.3

Copy BC-80X0

Procedure :

Using the slave reader and its BC-80X0 cradle, read the Restore Default
barcode, set the radio address, and then read the RS-232 interface barcode
from chapter 4

Connect the master BC-80X0 and the slave BC-80X0 (cradle to be configured)
together through two RS-232 serial interface cables and external power supply.
Accessory cables and power supply are available from your Datalogic
distributor to provide this connection.
RS-232 Cables:
Power Supply:

Read the Configuration Copy barcode below with a reader. Then place it onto
the master BC-80X0 cradle.
The configuration will be copied from the master BC-80X0 to the slave
BC-80X0. The reader signals the end of the procedure with a series of beeps.

Repeat the procedure above to configure other slave cradles.
NOTE: The master BC-80X0 can be configured for any interface.
190
of this manual or from the Quick Reference Guide.
CAB471 & CAB472
PG12
Copy Configuration
Ì$+ZZ3$-9Î