Powerscan ® D8330 Setup - Datalogic PowerScan D8330 Reference Manual

®
POWERSCAN D8330/M8300/M8300-DK
4.3 POWERSCAN
Read the restore default parameters code below.
1.
After reading the above code, go to par. 4.8 Interface Selection .
4.4 POWERSCAN
A rapid configuration procedure has been devised for point-to-point applications
where a single reader is associated exclusively with its own BC-80x0 base station
and where it is not necessary to set the Date and Time parameters.
A special pre-printed bind-address label provided in the BC-80x0 base station
package can be used to bind the PowerScan
the address coded on the label. The address is also written numerically on the label
to be easily recognized. Valid addresses are in the range from 0000 to 1999. Make
sure that all cradles used in the same area have different addresses.
To rapidly configure your point-to-point application:
1.
Apply the bind-address label onto the BC-80x0 base station as indicated in
the BC-80x0 Quick Reference Guide.
2.
When the BC-80X0 cradle is connected and powered, read the
Bind-Address label to pair the PowerScan
The green LED on the PowerScan
be positioned onto the cradle.
3.
Firmly position the reader onto the cradle within 10 seconds, a beep will be
emitted, signaling that the BC-80X0 cradle has been paired to the
PowerScan
Green LED
4.
Configure the BC-80X0 cradle, refer to the "BC-80X0 Quick Reference
Guide".
END of procedure. YOUR READER IS NOW READY TO READ CODES.
26
®
D8330 SETUP
Restore PowerScan
Ì$+$*oÎ
®
M8300/BC-80X0 POINT-TO-POINT SETUP
®
M8300, and the green LED on the reader will go off.
If it ever becomes necessary to change the reader,
just read the bind-address label applied to the cradle
and position the new reader onto the cradle.
Do not use multiple readers with this configuration
method.
®
D8330 Default
®
M8300 reader to the base station with
®
M8300 to the BC-80X0 cradle.
®
M8300 will blink: the reader is ready to