Datalogic PowerScan D8330 Reference Manual page 25

If using the adhesive strips:
a. Carefully clean the adhesive strip
seats of the base to remove any
impurities
adhesion.
b. Remove the protective plastic from
one side of the adhesive strips and
stick them onto the base surface.
c. Remove the plastic from the other
side of the strips and affix the base
to the wall as indicated in the figure
below.
6.
Attach the cradle on the base by sliding it along the mounting tabs until aligned.
7.
If mounting the BC-80X0 cradle, insert the antenna in the appropriate hole on
the body of the cradle and screw it clockwise until tight.
that could reduce
Inclined Base Wall-mounting
If using the mounting screws:
3.
Using the mounting holes on the
base as a pattern, mark the wall
where you desire to mount the BC-
80X0/C-8000.
4.
Drill the appropriate size holes and
insert the threaded dowels (not
provided) into the holes.
5.
Position the base on the wall as
indicated in the figure below and
affix it by means of the screws (not
provided).
INSTALLATION
17