Connecting The Data Gateway - Arris Touchstone DG1670 User Manual

Getting
Safety Started
A
Reset
USB
1
2
C
3
4
Ethernet
10/100/1000
Cable
E
Ethernet
Installation Configuration

Connecting the Data Gateway

1 Connect one end of the coax cable to the cable outlet or splitter, and the
other end to the Data Gateway's Cable connector (D). Tighten the con nec-
tions by hand, then tighten an additional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or
eliminate splitters between the cable jack and the Data Gateway. If you are
using MoCA for your home network, MoCA filters must be installed on any
B
legacy client devices. Your cable company will install these filters for you.
2 Insert the plug from the power cord into the Power connector on the back
of the Data Gateway (E) and insert the power cord into a convenient AC
outlet.
The Power light on the front of the Data Gateway lights up, then flashes
once (refer to the LED tables shown in Using the Data Gateway). See
bleshooting
D
3 Connect one end of the Ethernet cable to any Ethernet port on the back of
the Data Gateway, (C) and the other end to the Ethernet port on a com-
puter, hub, or broadband router.
Note: If you are connecting to a computer, use the Ethernet cable included
in the Data Gateway package.
Touchstone DG1670 Data Gateway User's Guide
Usage Troubleshooting
if the Power light does not turn on.
Glossary
Trou-
21